Manual Silicone Dispensing Equipment


Silicone sealants, in general, are difficult to apply due to their high viscosity. Since they cure upon contact with moisture in the air, they are sealed in aluminum tubes, plastic cartridges or pails. Some examples of common dispensing products are listed below. For more specific information, contact the sales office nearest you.

 

This gun is normally used for dispensing material in cartridges, but with a special attachement, it can be used for tubes. It has a simple sturdy construction, permitting easy operation

Dimesnsions

180 x 300 x 70 (mm)

Weight

250 g 

Power

None

Air Source

0.4 MPa max.

This dispenser discharges material from tubes. The quantity of discharge is easily controlled by pressure and time.

Dimesnsions

192 x 138 x 67 (mm)

Weight

2.3 kg

Power

240 VAC

Air Source

0.4-0.5 MPa max.

A cartridge is set in a plastic cylinder and the material is forced out by air pressure. This dispenser has a simple, sturdy construction, permitting easy operation. It is comparatively inexpensive.

Dimesnsions

180 x 300 x 70 (mm)

Weight

250g

Power

None

Air Source

0.4 MPa max.

A cartridge is set in an aluminum cartridge tank and is force-fed by air pressure. Pull the lever on the pencil gun to discharge the sealant.

Dimesnsions

100 x 100 x 300 (mm)

Weight

3 kg

Power

None

Air Source

0.4 MPa max.

This gear pump dispenser can discharge a very small amount of adhesive with medium viscosity at a constant rate. It needs only a 240VAC power supply.

Dimesnsions

270 x 250 x 108 (mm)

Weight

4.5 kg

Power

240 VAC

Air Source

None

This dispenser is used for high-viscosity silicone in a pail. A high pressure pump forces material and a trigger gun discharges material. Exchanging material is simplified with our wiper plate system. This system can discharge continuously.

Dimesnsions

420 x 665 x 1656 (mm)

Weight

90 kg

Air Source

0.4 ~ 0.6 MPa max.