Two-Part Adhesive Dispensing Equipment
 |
Dispesning two part adhesives requires that careful attention be paid to parameters such as material type, pot life, fillers, mixing ratio, viscosity, mixing time, mixing speed, as well as other conditions. ThreeBond is constantly developing new applicators to overcome these challanges. Below are some examples. |
 |
||||||||||||
|
This dispenser uses a gear pump to accurately control small amounts of discharge, even if the materail viscosity fluctuates |
 |
|
||||||||||||
|
This dispenser pumps and mixes high viscosity two-part silicone. When used with a robot, this foam bead forms a gasket that with chemical resistance, heat insulation, durability, elasticity and temperature resistance. |
 |
|
||||||||||||
|
This dispenser mixes and discharges 2 part UV resin. It uses a gear pump to control accuracy and a static motor for mixing. |
 |
|
For assistance with dispensing, contact the ThreeBond office nearest you